Toshiba TECRA M4 - page 291

4.26 LCD unit & FL inverter 4 Replacement Procedures
5. Turn up the insulator and disconnect the HV cable from the connector of FL inverter.
6. Remove the following screws securing the LCD unit.
• M2.5x4.0B FLAT BIND screw x4
7. With the bottom edge of the LCD unit on the display cover, raise the top edge of the
LCD unit.
NOTE: When putting the LCD unit on the display cover, lay a mat or something under the
LCD unit to protect the computer and the LCD from a scratch or breakage.
8. Peeling off the copper tape and glass tape and disconnect the LCD harness and
digitizer harness from the connectors on the back of LCD unit.
9. Remove the LCD unit from the display cover.
M2.5x4.0B FLAT BIND
Glass tape
HV cable
Insulator
M2.5x4.0B
FLAT BIND
LCD harness
Digitizer harness
Copper
tape
M2.5x4.0B FLAT BIND
Figure 4-39 Removing the LCD unit
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-61