Toshiba TECRA M4 - page 274

4 Replacement Procedures 4.17 LCD harness holder
4-44 [CONFIDENTIAL] TECRA M4 Maintenance Manual (960-521)
Installing the LCD harness holder
The following describes the procedure for installing the LCD harness holder (See Figure 4-
27).
1. Install the LCD harness holder to the cover assembly by fitting the boss and secure
it with the following screws.
• M2.5x6.0B FLAT BIND screw x2
2. Connecting the QI board cable to the connector CN9521 on the CN board and to the
connector CN9530 on the QI board, arrange the QI board cable along the guide of
LCD harness holder.
3. Connecting the CN board harness to the connector CN9502 on the system board and
to the connector CN9520 on the CN board, arrange the CN board harness along the
guide of LCD harness holder.
NOTE: When connecting the CN board harness, make sure that the connector with core
side is connected to the CN board.
4. Connect the LCD harness to the connector CN5501 on the system board and arrange
the LCD harness along the guide of LCD harness holder.
5. Connecting the USB harness to the connector CN4612 on the system board and to
the connector CN4621 on the CN board, arrange the USB harness along the guide of
LCD harness holder under the insulator.