4.4 Memory module B 4 Replacement Procedures
2. Open the left and right latches outside and remove the memory module B.
Memory module B
Latch
Latch
Figure 4-5 Removing the memory module B
Installing the memory module B
To install the memory module B, make sure the computer is in boot mode and powered off.
Then perform the following procedure. (See Figure 4-4 and 4-5.)
1. Insert the memory module B into the connector slantwise (the terminal side first) and
press it to connect firmly.
CAUTION: The power must be turned off when you insert the memory module. Inserting
the memory module with the power on risks damaging the module or the
computer itself.
Never press hard or bend the memory module.
After installing the memory module, confirm that the memory module is fixed
with the left and right latches.
2. Install the memory slot cover and secure it with the screw.
TECRA M9 Maintenance Manual (960-631) [CONFIDENTIAL] 4-13