4 Replacement Procedures 4.14 Cover assembly and Base assembly
4.14 Cover assembly and Base assembly Removing the cover assembly and base assembly
The following describes the procedure for removing the cover assembly and base assembly.
(See Figure 4-24 and 4-25.)
1. Close the display and turn over the computer.
2. Remove the following screws.
• M2.5×8B FLAT HEAD screw ×3 (“8” in the figure below)
• M2.5×16B FLAT HEAD screw ×6 (“16” in the figure below)
8
8
816
16
16
16
16
16
Figure 4-24 Removing the cover assembly and base assembly (1)
4-36 [CONFIDENTIAL] TECRA M9 Maintenance Manual (960-631)