4.22 North bridge heat sink/CPU heat sink/Fan/CPU 4 Replacement Procedures
3. Remove the following screws in the reverse order of the number marked on the CPU
hold plate.
• M2×4B BIND screw ×3
4. Remove the CPU hold plate and metal plates.
5. Disconnect the fan cable from the connector CN8771 on the system board.
6. Remove the CPU heat sink (with a fan).
M2x4B BIND
Metal plate
CPU heat sink
(With a fan)
CPU hold plate
Fan cable
CN8771
A
cetate tape
Figure 4-35 Removing the CPU heat sink (with a fan)
TECRA M9 Maintenance Manual (960-631) [CONFIDENTIAL] 4-51