4 Replacement Procedures 4.10 Keyboard/Memory module A
4-28 [CONFIDENTIAL] TECRA M9 Maintenance Manual (960-631)
Installing the keyboard/Memory module A
The following describes the procedure for installing the keyboard/memory module A. (See
Figure 4-14 to 4-17.)
1. Place the keyboard face down on the palm rest.
2. Connect the keyboard cable to the connector CN3230 on the system board.
CAUTION: Extra portion of the keyboard cable must be put under the palm rest.
3. Insert the memory module A into the connector slantwise (the terminal side first) and
press it to connect firmly.
CAUTION: The power must be turned off when you insert the memory module. Inserting
the memory module with the power on risks damaging the module or the
computer itself.
Never press hard or bend the memory module.
After installing the memory module, confirm that the memory module is fixed
with the left and right latches.
4. Install the memory slot cover and secure it with the following screws.
• M2.5×8B FLAT HEAD screw ×2
5. Turn the keyboard face up and set it in place.
6. Secure the keyboard with the following screws.
• M2.5×4B FLAT HEAD screw ×2