4.15 Fingerprint sensor board 4 Replacement Procedures
TECRA M9 Maintenance Manual (960-631) [CONFIDENTIAL] 4-41
Installing the Fingerprint sensor board
The following describes the procedure for installing the fingerprint sensor board. (See Figure
4-26 and 4-27.)
1. Connect the fingerprint sensor cable to the connector on the fingerprint sensor board.
2. Stick a new double-sided tape in place and install the fingerprint sensor board.
NOTE: Do not reuse the removed double-sided tape.
3. Install the fingerprint sensor board hold plate while sliding it to the guides.
4. Arrange the fingerprint sensor cable and stick the glass tape in place.