Toshiba TECRA M9 - page 254

4 Replacement Procedures 4.6 Slim select bay module
4-20 [CONFIDENTIAL] TECRA M9 Maintenance Manual (960-631)
Installing the slim select bay module
The following describes the procedure for installing the slim select bay module. (See Figure
4-9 and 4-10.)
1. Install the ODD side assembly to the optical drive assembly and secure it with the
following screws.
• M2×6C BIND screw ×1
• M2×22C BIND screw ×1
2. Install the connector base to the optical drive assembly and secure it with the
following screw.
• M2×2.8C S-THIN HEAD screw ×1
3. Install the connector cover and connector to the optical drive assembly and secure it
with the following screws.
• M2×6C BIND screw ×2
4. Insert the slim select bay module into the computer to connect it to the connector on
the system board. Press to ensure a firm connection.
5. Remove the following screw from the screw hole. Then secure the latch with the
removed screw. (The slim select bay is locked.)
• M2.5×4B FLAT HEAD screw ×1