Toshiba TECRA M9 - page 272

4 Replacement Procedures 4.14 Cover assembly and Base assembly
4-38 [CONFIDENTIAL] TECRA M9 Maintenance Manual (960-631)
Installing the Cover assembly and Base assembly
The following describes the procedure for installing the cover assembly and base assembly.
(See Figure 4-24 and 4-25.)
1. Install the cover assembly on the base assembly.
2. Connect the LCD cable, speaker cable, switch cable and finger print sensor cable
to the connector CN5000, CN6170, CN9500 and CN9550 on the system board.
3. Secure the cover assembly and base assembly with the following screws.
• M2×4B BIND screw ×1
• M2.5×8B FLAT HEAD screw ×1
4. Close the display and turn over the computer.
5. Secure the cover assembly and base assembly with the following screws.
• M2.5×8B FLAT HEAD screw ×3 (“8” in the figure 4-24)
• M2.5×16B FLAT HEAD screw ×6 (“16” in the figure 4-24)