HW Setup

CPU

This function allows you to set the processor's operating mode.

Dynamic CPU Frequency Mode

This option allows you to configure the power saving modes associated with the processor - the following settings are available:

Dynamically

The processor's power consumption and

Switchable

automatic clock speed switching functions are

 

enabled - in use the processor's operation is

 

automatically switched when necessary (default).

 

 

Always High

The processor's power consumption and

 

automatic clock speed switching functions are

 

disabled - in use the processor will always run at

 

its highest level of power consumption and its

 

highest speed.

 

 

Always Low

The processor's power consumption and

 

automatic clock speed switching functions are

 

disabled - in use the processor will always run at

 

a lower level of power consumption and a low

 

speed.

LAN

Wake-up on LAN

This feature lets the computer’s power be turned on when it receives a wake-up signal from the LAN.

Do not install or remove a memory module while Wake-up on LAN is enabled.

■The Wake-up on LAN function consumes power even when the system is off. Leave the AC adaptor connected while using this feature.

■To enable it, you must check both the "Allow the device to wake the computer" and "Only allow management stations to wake the computer" check box within the "Intel Network Connection".

Power will be automatically turned on when a signal is received from an administrator's computer which is connected via a network.

The following settings can be changed when the Built-in LAN is Enabled.

Connect the AC adaptor when using the Wake-up on LAN function. The battery retention time will be shorter than the times listed in this manual when this function is enabled. Refer to the section in chapter 6, Retaining data with power off.

Enabled

Enables Wake-up on LAN (Default).

Disabled

Disables Wake-up on LAN.

User’s Manual

7-6