zInterface Description
| Interface | Port |
| Description |
| WAN | 1~4 |
| The WAN port is for connecting the router to a DSL/Cable |
|
| modem or Ethernet by the RJ45 cable. | ||
|
|
|
| |
|
|
|
|
|
| LAN | 2~5 |
| The LAN port is for connecting the router to the local PCs or |
|
| switches by the RJ45 cable. | ||
|
|
|
| |
|
|
|
|
|
| Console | / |
| The Console port is for connecting with the serial port of a |
|
| computer or terminal to monitor and configure the router. | ||
|
|
|
| |
|
|
|
|
|
zReset button
Use the button to restore the router to the factory defaults. With the router powered on, use a pin to press and hold the Reset button (about 5 seconds). If the SYS LED is flashing 5 times in high frequency, release the Reset button. It means the router is restored successfully. The default management address of the router is http://192.168.0.1, and the default username and the password are both admin.
2.3.2 Rear Panel
The rear panel of
zAC Power Receptacle
Connect the female connector of the power cord to this power receptacle, and the male connector to the AC power outlet. Please make sure the voltage of the power supply meets the requirement of the input voltage
zGrounding Terminal
The router already comes with lightning protection mechanism. You can also ground the router through the PE (Protecting Earth) cable of AC cord or with Ground Cable.
Note:
Please only use the power cord provided with this router.
