Power Supply Unit (RPS-7)

In order to minimize hum, and also to break up the total weight and to protect the body of the RX-7 from rough transportation, RX-7 series mixers are equipped with a separately packaged power supply unit (RPS-7).

The RX-7 is designed so that without the connection of the accessory umbilical cable between the PSM-7 power supply module and the RPS-7, power is not supplied to the mixer even if the power switch on the RPS-7 is on. The power switch on the RPS-7, therefore, must be turned on after the connection between the PSM-7 and RPS-7 is completed.

The RPS-7 is a regulated DC power supply unit to activate the RX-7.

(Fig. 14)

1. AC Fuse

The fuse should be replaced with one of identical value and type.

2.Pilot Lamp

3.Power Switch

Pushbutton alternately switches AC power on and off.

4.DC output connector

With the accessory umbilical cable, the DC output is connected to the PSM-7 (Power Supply Module).

5.Ground Terminal

6.AC Inlet

Plug an accessory AC power cord into the AC inlet and secure it with the cord clamp.

— 21 —

Page 22
Image 22
TP-Link RX-7-248 Power Supply Unit RPS-7, AC Fuse, Pilot Lamp Power Switch, DC output connector, Ground Terminal AC Inlet