TP-Link TL-R470T+ Rear Panel,  AC Power Receptacle,  Reset button,  Interface Description Port

2.3.2 Rear Panel

The rear panel of TL-R470T+ is shown as the following figure.

AC Power Receptacle

Connect the female connector of the power cord to this power receptacle, and the male connector to the AC power outlet. Please make sure the voltage of the power supply meets the requirement of the input voltage (100-240V~ 50/60Hz).

RESET button

Use the button to restore the router to the factory defaults. With the router powered on, use a pin to press and hold the RESET button (about 5 seconds). If the SYS LED is flashing 5 times in high frequency, release the RESET button. It means the router is restored successfully. The default management address of the router is http://192.168.0.1, and the default username and the password are both admin.

Interface Description

Interface	Port	Description
WAN	1–4	The WAN port is for connecting the router to a DSL/Cable
		modem or Ethernet by the RJ45 cable.
LAN	2–5	The LAN port is for connecting the router to the local PCs or
		switches by the RJ45 cable.

Note:

Please only use the power cord provided with this router.

-7-