Rear Panel, Antenna | TRENDnet TEW-670APB specification

Rear Panel

The figure below shows the rear panel of the Access Point

Rear Panel

LAN

Ethernet port with 10/100Mbps Fast Ethernet connections, connect this port to a switch/hub.

RESET

Press the “RESET” button for more than 5 seconds buttonto reset the settings back to factory default.

Power

Connect the DC Power Adapter plug to the AP’s power jack.

Antenna

Two external 3 dBi dipole antennas.

5

Image 12

TRENDnet TEW-670APB manual Rear Panel, Antenna

Contents

Page Regulatory Information/disclaimers Federal Communication Commission Interference Statement FCC Radiation Exposure Statement Europe EU Declaration of ConformityEN60950-1 EN 50385 EN 300 328 V1.7.1 EN 301 489-1 V1.6.1EN 301 489-17 V1.2.1 0560 Page Table of Content About this Guide Overview of this User’s Guide Features Introduction Unpacking and Setup SetupUnpacking Power Hardware InstalationFront panel Status Rear Panel Antenna Side Panel Hardware connections Connect to the Switch/Hub/Router Check the installation Configuring the Wireless LAN Access Point Login to the Wireless AP through WlanLogin to the Wireless AP through LAN Main Screen of the Access Point Set your new passwordWizard Secure your Wireless Network Page Good WEP Status Save and RestartPage Basic Setting WEP Encryption WPA/WPA2-EAP Security Rasius Server 1/2WPA-PSK/WPA2-PSK Security IP Setting Advanced Wireless Setting Access Point Mode Wireless Bridge mode Repeater mode Repeater mode configuration Security Click Apply Tools Wi-Fi Protected Setup Technical Specifications General Physical and Environmental Network Glossary Page Page Page Page Page Limited Warranty