Advanced Wireless Setting, Access Point Mode | TRENDnet TEW-670APB

Advanced Wireless Setting

This page contains configurations for advanced users, changes applied reflects the wireless performance and operating modes.

Mode: The WLAN AP supports three operation modes for Access Point, Wireless Bridge, Repeater modes.

Access Point Mode

Configure the AP to Access Point mode; with this mode, WLAN clients can access LAN or other WLAN clients through this AP.

AP mode application

18

Image 26

TRENDnet TEW-670APB manual Advanced Wireless Setting, Access Point Mode

Contents

Page Regulatory Information/disclaimers Federal Communication Commission Interference Statement EN60950-1 FCC Radiation Exposure StatementEurope EU Declaration of Conformity EN 50385 EN 301 489-17 V1.2.1 EN 300 328 V1.7.1EN 301 489-1 V1.6.1 0560 Page Table of Content About this Guide Overview of this User’s Guide Features Introduction Unpacking Unpacking and SetupSetup Front panel PowerHardware Instalation Status Rear Panel Antenna Side Panel Hardware connections Connect to the Switch/Hub/Router Check the installation Login to the Wireless AP through LAN Configuring the Wireless LAN Access PointLogin to the Wireless AP through Wlan Wizard Main Screen of the Access PointSet your new password Secure your Wireless Network Page Good WEP Status Save and RestartPage Basic Setting WEP Encryption WPA-PSK/WPA2-PSK Security WPA/WPA2-EAP SecurityRasius Server 1/2 IP Setting Advanced Wireless Setting Access Point Mode Wireless Bridge mode Repeater mode Repeater mode configuration Security Click Apply Tools Wi-Fi Protected Setup Technical Specifications General Physical and Environmental Network Glossary Page Page Page Page Page Limited Warranty