CONFIGURING THE WIRELESS LAN ACCESS POINT

The Wireless Access Point has a Web GUI interface for easy configurations through a Web Browser. A network manager can manage, control and monitor the AP from the local LAN. This section indicates how to configure the AP to enable its functions.

Login to the Wireless AP through WLAN

Before configuring the Wireless AP through WLAN, make sure that the SSID, Channel and encryption settings are set properly.

The default setting of the Wireless AP that you will use:

‹SSID: TRENDnet670

‹Wireless Mode: Access point

‹Channel: 6

‹Channel Width: 20MHz

‹Security: disabled

‹IP address: 192.168.10.100

Login to the Wireless AP through LAN

Before you configure this device, note that when the AP is configured through an Ethernet connection, make sure the manager PC must be set on same the IP network. For example, when the default network address of the default IP address on the AP is 192.168.10.100, then the manager PC should be set at 192.168.10.x (where x is a number excluding 100), and the default subnet mask is 255.255.255.0.

Open Internet Explorer 6.0 or above Web browser.

Enter IP address http://192.168.10.100 (the factory-default IP address setting) on the address bar.

When the below screen appears enter your User name and Password, both of the default Username and Password is “admin”

7

Page 15
Image 15
TRENDnet TEW-670APB manual Configuring the Wireless LAN Access Point, Login to the Wireless AP through Wlan