Wireless Bridge mode | TRENDnet TEW-670APB specification

Wireless Bridge mode

Configure to the wireless bridge mode; the TEW-670APB will be a LAN to LAN wireless Ethernet bridge between two separated Ethernet LAN segments.

Note: The Wireless Bridge mode only supports in using two more of the TEW- 670APB.

Wireless Bridge mode application

WDS Wireless Bridge mode configuration

19

Image 27

TRENDnet TEW-670APB manual Wireless Bridge mode

Contents

Page Federal Communication Commission Interference Statement Regulatory Information/disclaimers EN 50385 FCC Radiation Exposure StatementEurope EU Declaration of Conformity EN60950-1 EN 300 328 V1.7.1 EN 301 489-1 V1.6.1EN 301 489-17 V1.2.1 0560 Page Table of Content Overview of this User’s Guide About this Guide Introduction Features Unpacking and Setup SetupUnpacking Status PowerHardware Instalation Front panel Antenna Rear Panel Hardware connections Side Panel Check the installation Connect to the Switch/Hub/Router Configuring the Wireless LAN Access Point Login to the Wireless AP through WlanLogin to the Wireless AP through LAN Main Screen of the Access Point Set your new passwordWizard Secure your Wireless Network Page Good WEP Save and Restart StatusPage Basic Setting WEP Encryption WPA/WPA2-EAP Security Rasius Server 1/2WPA-PSK/WPA2-PSK Security IP Setting Access Point Mode Advanced Wireless Setting Wireless Bridge mode Repeater mode Repeater mode configuration Click Apply Security Tools Wi-Fi Protected Setup General Technical Specifications Physical and Environmental Network Glossary Page Page Page Page Page Limited Warranty