Assembly

ASSEMBLY

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at 1-888-6 1 1-6708.

Remove Generator From Carton

I . Set the carton on a rigid flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top t o bottom.

4.Leave generator on carton t o install wheel kit.

Hex Nut -

InstallWheel Kit

NOTE:Wheel kit is.not intended for over-the-road use. You will need the following tools t o install these components:

112" o r 13mm wrench

Socket wrench with a 112" o r 13mm socket

Pliers

Refer to Figure I and install the wheel kit as follows:

I.Tip generator so that engine end is up.

2.Slide axle through both mounting brackets.

3.Place a wheel on each side with air valve facing out.

4.Place a washer on axle and then place an e-ring in axle groove.

5.Install e-ring with pliers, squeezing from top of e-ring t o bottom of axle. .

6.Repeat step 3 through 5 t o secure second wheel.