Section 3: Assemblv
7.Tip generator so that engine side is down.
8.Line up holes in support leg with holes in generator frame.
9.Atpch support leg using t w o short (M8 x 16mm) cap screws and t w o locking hex nuts.Tighten with a 112" o'r13mm socket and wrench.
10.Oh support leg end of generator, slide handle onto center of top of frame.
I I. Attach handle using t w o long (M8 x 45mm) cap screws and t w o locking hex nuts.Tighten with a 112" o r 13mm socket and wrench.
12.Return generator t o normal operating position (resting on wheels and support leg).
13.Check that tires are inflated t o value marked on tire o r within 15 and 40 psi.
BEFORE STARTING T H E
,E N G I N E
Add Engine Oil
Move generator t o a flat, level surface.
Refer t o engine owner'smanual and follow oil recommendations and instructions.
II
C A U T I O NI
*Refer to engine manual for 011fill information.
Damage to equipment resulting from failure to follow this instruction will void warranty.
MOTE: Check oil often during engine
NOTE: The generator assembly rotates on a prelubricated and sealed ball bearing that requires n o additional lubrication for the life of the bearing.
Add Fuel
gasoline. Exhaust Emission Control System: EM (Engine Modifications).
Turn generator OFF and let it cool at least 2 minutes before removing fuel cap. Loosen cap slowly to relieve pressure in
Fill fuel tank outdoors.
DO NOT overfill tank.Allow space for fuel expansion.
Keep fuel away from sparks, open flames, pilot lights,heat,and other ignition sources.
DO NOT light a cigarette or smoke.
I.Use clean, fresh, regular UNLEADED fuel with a minimum of 85 octane. D O N O T use fuel which contains Methanol. D O N O T mix oil with fuel.
2.Clean area around fuel fill cap, remove cap.
3.Slowly add regular unleaded fuel t o fuel tank Be careful not t o overfill.Allow about 1.5" o f tank space for fuel
expansion (Figure 2).
4.Install fuel cap and wipe up any spilled fuel.