U S I N G T H E GENERATOR Generator Location'

Generator Clearance

System Ground

The generator has a system ground that connects the generator frame components t o the ground terminals on the AC output receptacles.The system ground is connected t o the AC neutral wire (see "Equipment Description", earlier in this manual).

Special Requirements

There may be Federal o r State Occupational Safety and Health Administration (OSHA) regulations, local codes, o r ordinances that apply t o the intended use of the generator. Please consult a qualified electrician, electrical inspector, o r the local agency having jurisdiction.

In some areas, generators are required t o be registered with local utility companies.

If the generator is used at a construction site, there may be additional regulations which must be observed.

Connecting to a B~~~ilding'sElectrical System

Connections for standby power t o a building'selectrical system must be made by a qualified electrician.The connection must isolate the generator power from utility power, and must comply with all applicable laws and electrical codes.

highly conductive area, such as metal decking or steel work. . DO NOT touch bare wires or receptacles.

DO NOT use generator with electrical cords which are worn, frayed, bare or otherwise damaged.

DO NOT operate generator in the rain.

DO NOT handle generator or electrical cords while standing in water, while barefoot, or while hands or feet are wet.

nqualified persons or children to operate or

The generator must be at least 5 ft. (1 52 cm) from structures having combustible walls and/or other combustible materials. Leave at least 3 ft. (92 cm) all around generator including overhead, for adequate cooling, maintenance and servicing.

Place generator in a well ventilated area, which will allow for removal of deadly exhaust gas. D O N O T place

..kenerator where exhaust gas could accumulate and enter inside o r be drawn into a potentially occupied building. Ensure exhaust gas is kept away from any windows, doors, ventilation intakes o r other openings that can allow exhaust gas t o collect in a confined area (Figure 3). Prevailing winds and air currents should be taken into consideration when positioning generator.

Typical Generator Shown