True Fitness 600, 725, 700 manual Control Panel, Treadbelt Tension & Safety Features

Treadbelt Tension & Safety Features 1-5

2-1 Control Panel Functions

NOTE: Your authorized True dealer may provide additional support.

ALTERNATIVE METHOD

1.Stand beside the treadmill, insert the safety key into the bottom of the control panel and follow operating instructions for running the treadmill at 5 mph. (Section 2.5)

2.If the belt is off-center to the right, turn the left roller adjustment bolt counter clock-wise 1/4 turn. If the belt is off-center to the left, turn the left roller adjustment bolt 1/4 turn clockwise. (Figure 1 Detail 1)

3.Let the machine run for several minutes to check the alignment. (Belt alignment does not need to be perfect). If more correction is needed, turn the adjustment bolt 1/4 turn and check again.

TREADBELT TENSION:

To assure maximum life of the treadbelt, roller and drive motor, make sure the treadbelt tension is set correctly. (Your treadbelt has been properly tensioned at the factory.)

1

Figure 1

¥Turn both rear roller adjustment bolts (Detail 1) counter-clockwise until treadbelt just begins slipping when walking on it, then turn both rear roller adjustment bolts clockwise in equal quarter turn increments until treadbelt stops slipping. NOTE: Be sure to run on treadbelt to ensure that the treadbelt does not slip while under load.

SAFETY FEATURES

PADDED HAND RAIL

The padded hand rail is mounted to the rear of the control console. The bar provides a convenient support to use throughout your workout.

ON/OFF SWITCH

The on/off switch is located to the right of the power cord on the front of the machine. It completely removes AC power from your treadmill. It is recommended that you use this switch to turn the machine off after each workout.

CIRCUIT BREAKER

Your TRUE treadmill is protected from overload by a 20 amp circuit breaker that can be reset in the event of a power overload. It is located to the left of the power cord.

SAFETY KEY AND LANYARD

You can protect yourself from injuries resulting from unexpected loss of balance by attaching the lanyard to your clothing at about waist height when you use your treadmill. When the safety key is detached, your treadmill will not operate.

REAR ROLLER SHIELDS

Steel guards over the ends of the rear roller prevent towels and other items from getting caught in the running belt.

FULLY ENCLOSED MOTOR

The motor and flywheel are fully enclosed in a protective metal compartment.

LOW PROFILE FRAME

To enhance safety, TRUE treadmills are designed to be as low to the ground as possible.

600 CONTROL PANEL