Installation and Operation
Installing the UPS is as easy as following the steps shown below. Be aware that the Power Switch must be kept in the “ON” position, otherwise, the UPS will be disabled and your equipment will not be protected during a power failure.
1.Inspection
Remove the UPS from its packaging and inspect it for damage that may have occurred during shipping. If any damage is discovered, repack the unit and return it to the place of purchase.
2.Placement
Install the UPS unit in any protected environment that provides adequate airflow around the unit, and is free from excessive dust, corrosive fumes and conductive contaminants. Do not operate your UPS in an environment where the ambient temperature is above 40°C or 104°F, or where humidity is high. Place the UPS unit away from monitor at least 20cm to avoid interference.
3.Charging
This unit is shipped from the factory with its internal battery fully charged. However, some energy may be lost during shipping so the battery should be recharged before use. Plug the unit into an appropriate power supply and allow the UPS to charge fully by leaving it plugged in for 10 hours.
6
