7.Press .

The next available block displays.

8.Repeat Steps 6 and 7 until you have selected a size code for each block.

For specifics about each size code, see Fleet Map Size Codes in the Appendix.

9.Press .

The scanner exits the Trunking Programming mode, acquires the data channel, and begins searching using the map you’ve programmed.

Note: It is required that the trunked frequency has been programmed before programming a

fleet map.

Programming a Hybrid System

A Hybrid system is simply a Type I system with some blocks designated as Type II blocks. To program a Hybrid system, follow the steps listed in Programming a Fleet Map in the previous section. However, if you want a block to be Type II, select Size Code S-0.

When you begin searching a trunking bank with a Hybrid Fleet Map, you will see both types of system Ids. That is, Type II Ids usually appear as an even number without a dash; Type I Ids appear as a three or four digit number, followed by a hyphen, followed by a one or two digit number. See page 68 for more information.

59

Page 59
Image 59
Uniden BC 245XLT manual Programming a Hybrid System