Do not use the telephone to report a gas leak in the vicinity of the leak.

Use only the power cord and batteries indicated in this manual.

Do not dispose of batteries in a fire. They may explode. Check with local codes for possible special disposal instructions.

Do not place the handset in any charging cradle without the battery installed and the battery cover securely in place.

SAVE THESE INSTRUCTIONS!

CAUTION! Risk of explosion if battery is replaced by an incorrect type! Dispose of used batteries according to the instructions. Do not open or mutilate the battery. Disconnect the battery before shipping this product.

For more details, see the Important Information section.

Getting Started

Installing Your Phone

Charge the battery

1. Unpack all handsets, batteries, and battery covers. If you need to remove a battery cover, press in on the notch and slide the cover down.

2.Line up the battery connector with the jack inside the handset and push the connector in until it clicks into place. Tug gently on the wires to make sure the battery pack is securely connected.

3.Replace the cover and slide it up into place.

4.Connect the base AC adapter to the ac in 7.8V jack on the base. Run the cord through the indent and out the back.

5.If you have accessory handsets, connect each charger’s applicable AC adapter to the power jack.

If you have a DRX312 handset with a MULTIRANGE charger or a DWX317 waterproof handset, be sure to use the correct AC

Page 4
Image 4
Uniden DECT3181 manual Getting Started, Installing Your Phone, Charge the battery