Resetting the Scanner | Uniden UBC72XLT specs

Resetting the Scanner

If the scanner's display locks up or stops operating properly, you might need to reset the scanner.

Caution: This procedure clears all the information you have stored in the scanner. Before you reset the scanner, try turning it off and on to see if it begins working properly. Reset the scanner only when you are sure it is not working properly.

1.Turn off the scanner.

2.While holding down 2, 9, and Hold, turn on the scanner. It takes about 3 seconds to initialize and CLEAr appears.

Troubleshooting

48

Image 48

Uniden UBC72XLT owner manual Resetting the Scanner

Contents

UBC72XLT Scanner Precautions Precautions UBC72XLT Controls and Display UBC72XLT Controls and Display Contents Contents Introduction Introduction Frequency Range Step Mode Transmission MHz KHz Feature Highlights Feature Highlights About This Manual Feature Highlights What is Scanning? What is Searching?Understanding Scanning Conventional Scanning Simplex Operation Repeater Operation Where To Obtain More Information Information On The Internet Included With Your Scanner Included With Your Scanner Setting Up Your Scanner Using Internal BatteriesUsing Non-Rechargeable Batteries Setting Up Your Scanner Setting Up Your Scanner Page Setting Up Your Scanner Using AC Power Connecting the Antenna Connecting an Earphone/Headphone Connecting an Extension SpeakerConnecting an Optional Antenna Attaching the Belt Clip About Your Scanner About Your Scanner Look At The Keypad Hold Func + Pgm Look At The Display About Your Scanner Service Banks Understanding BanksChannel-Storage Banks Turning On The Scanner Setting Squelch OperationStoring Known Frequencies Into Channels Operation Service Search Searching For and Temporarily Storing Active Frequencies Storing Frequencies into Channels During Service Search Scanning the Stored Channels Manually Selecting a Channel Special Features Special FeaturesClose CallTM RF Capture Technology Setting the Close Call Options Special Features Using Close Call RF Capture Chain Search Mode Chain Search Chain Search Hold Mode Setting the Search Range Direct Entry Search Direct Entry Search Hold Mode Search Skip Memory Delay Turning Channel-Storage Banks On and Off Locking Out Channels Priority Using Keylock Using the Display Backlight Troubleshooting Troubleshooting Troubleshooting Resetting the Scanner Care and Maintenance CleaningCare and Maintenance General Use Repairs Birdies Specifications Specifications Seconds Optional Accessories Optional Accessories One Year Limited Warranty One-Year Limited Warranty Uniden Australia PTY Limited Service Division Thank YOU for Buying a Uniden Product