UP354BH(WDECT2355+2) OM 5/14/04 10:51 AM Page 29
When speaking on the base
1) Press 
or 
speaker on the handset to initiate the
2) To hang up, return the handset to the cradle, or press
key on the handset. The base will still be connected to the call.
FIND HANDSET
To locate the handset, press mute/find handset on the base when the base is in standby mode. All registered handsets beeps for 60 seconds, and Paging appears on the handset display. To cancel paging, press any key on the handset or mute/find handset on the base.
FLASH AND CALL WAITING
If you have Call Waiting service and a call waiting tone
sounds while you are on a call, press 
(or flash on the base) to accept the waiting call. There is a short pause, and then you will hear the new caller. To return to
the original caller, press 
(or flash on the base) again.
NEW MESSAGE LED
The new message LED on the handset flashes when you have new messages in your answering system. The LED stops flashing when all new messages are played back (see "Using your Answering System" on page 50).
[ 29 ]
