Unified Brands HY-6G(CE) service manual 10.30Door Locking Pin P/N Lock Nut P/N, OM/SM-HY-6GCE33

6.Install spring onto brass roller, then place square plate over spring.

7.Apply Locktite 242 to Keps nut and install Keps nut.

8.Install spring support pin, then push the retaining ring onto the pin using a screwdriver.

9.Hold door spring open with a screwdriver or similar tool, hold door handle in the down position and install the U-channel, top end first - then lower channel into position. Check that spring opens when door handle is pushed up.

10.Apply Locktite 242 to U-channel mounting screws, then install the screws.

11.Replace the two screws in the U-channel, applying Locktite 242 to secure them in place.

10.30Door Locking Pin P/N 078914

Lock Nut P/N 003823

1. Turn steamer off and allow it to cool.

2.Note and record the distance between the lock nut and the end of the (bullet shaped) door locking pin. This information is important and will be needed for installation.

3.Loosen lock nut and remove lock nut and door pin (bullet) from front panel.

4.To install new door locking pin, coat locking pin threads with NEVER-SEEZ high temperature compound.

5.Install locking pin and lock nut. The lock nut to end- of-bullet distance should be approximately the same as measured above, in Step 2.

10.31Indicator Neons (Lockout)

1.Turn off main gas supply

2.Turn off oven power and disconnect from branch circuit power.

3.Remove upper right side panel

4.Replace neons as necessary.

OM/SM-HY-6G(CE) 33