System Default Settings

Network

When using this unit on a network, go to SET UP section = [System] = [Network], and set the [Network] command to “ON”. Then go to SET UP section = [System] = [Network], and set the [DHCP/Manual] command either to use DHCP (Dynamic Host Configuration Protocol) or input the IP address used, together with sub-net mask and Gateway address.

If “DHCP” is selected, confirm that a DHCP server in fact exists. If no server exists, a longer time will be required for the unit to boot to the idling condition when the power is turned on. When “DHCP” is

selected, the [IP Address] command will display the address automatically allocated to the recorder. Also, setting [Network] to “ON” makes it possible to check the MAC address of this unit.

Note:

Be very careful when setting IP address, sub-net mask, and Gateway addresses. Failure to set the correct values may not only make it impossible to connect to a network, but cause malfunctions throughout the network. If you are unsure of the proper values to set for these items, consult your network administrator.

 

UPS Support

 

Whenever the power to this unit is turned OFF, the

 

unit performs a shutdown operation. An unintentional

 

power interruption results in the power being

 

disconnected without the shutdown operation being

 

performed, thus resulting in potential malfunctions. In

 

order to avoid such malfunctions, the use of an

 

uninterrupted power supply (UPS) is recommended.

 

By going to SET UP section = [System] = [UPS

 

Setting] = [Model], you can select APC Smart-

 

UPS 700 or Smart-UPS 500 (Note).

 

Note:

SET UP section = [System] = [Network]

Smart-UPS 500 is for use in Japan only.

 

Also, if power is interrupted and the UPS operates,

 

the time before automatic shutdown is initiated can

 

be set to 30 seconds or 60 seconds (SET UP section

 

= [System] = [UPS Setting] = [Shutdown

 

Delay]). In this way, the shutdown operation will be

 

avoided if normal power is restored within the

 

selected time interval.

SET UP section = [System] = [Network] = [DHCP/Manual] = [DHCP]

SET UP section = [System] = [Network] = [DHCP/Manual] = [Manual]

30

SET UP section = [System] = [UPS Setting]

Use the UPS products below, manufactured by

AMERICAN POWER CONVERSION CORP. (APC).

Smart-UPS 700VA

(Part Number: SU700NET)

Connection of other manufacturers’ UPS will not result in proper operation.

PRV-LX1 En