INSTALLATION
Continued
Motor
Mount
Foam
Shipping
Brace
Figure 11 - Removing Shipping Brace
Lamps and lava Rock
Before operating fireplace, lamp bulbs must be inspected and lava rock may be added if desired.
1.Lift log bed off hearth base to gain access to lamp fixtures (log bed is attached with contact magnets).
2.Turn on power to light circuit and check that all bulbs are operating. Bulb place- ment front left to right are red, yellow and orange (see Figure 12).
Note: If bulbs need replacing, see Replac- ing Light Bulbs, page 15. Be careful not to tear or damage reflective strips. If they have come loose, ends can be easily reattached or replaced at support brackets. See Replacing Reflective Ribbons, page 19.
3.Center log bed over opening between viewing panel screen and grate.
4.Cover remaining hearth area with 1/4" of lava rock (provided), if desired.
Viewing Panel
Screen
Red
Yellow
Orange
Grate 
Log Bed
Figure 12 - Bulb Placement
Features and
Operation
This electronic fireplace series features a random flame effect, and a realistic log bed with glistening embers that can be adjusted for flame speed and light intensity. VE36/32LH models have a circulating heater, rated at 1100 Watts. Models VE36/32LB and VE36/ 32LBH include a hand detailed, textured,
Access controls by pulling two handle tabs of upper louver until panel releases from magnetic catches and swings down to open position (see Figure 13).
