Vanguard VE32L Screws from packaging. Blower is pre, Wired for convenience, Into position, 25

Accessory

Installation

Continued

7.	Remove blower/heater assembly with 4
	screws from packaging. Blower is pre-
	wired for convenience.
8.	Align blower assembly over hole pattern on
	blower mount and attach with 4 pan head
	screws provided (see Figures 22 and 23).
9.	With discharge pointing towards you, guide
	assembled blower mount into fireplace
	and center rear mounting flanges between
	standoff brackets at rear of the fireplace.
10.	Lift blower mount up and position 4 locking
	tabs through notched openings in firebox
	top. Slide assembly forward until locked
	into position.
11.	Remove control panel knockout plug lo-
	cated in heater switch position by pressing
	locking tabs and pushing plug out through
	front of panel (see Figure 24).

14.Connect black heater wire to terminal marked 'N-1' on heater power switch (see Figure 26, page 12). Note: On alternate style heaters white and black wires are connected common to terminal 'N-1' (see Figure 27, page 12).

Heater/

Blower

Assembly

Harness

Strap

Blower

Mount

Mounting

Screws

Figure 22 - Mounting Heater/Blower

12.	Firmly insert red power switch into open
	mount location with “ON” (I) indicator
	positioned on top.
13.	Connect white heater wire to neutral
	connection marked 'B' or 'A' on terminal
	block. See partial wiring diagram, Figure
	25, page 12.

Notches for

Control Cover Blower Mount

Notch (1 of 4)

Control

Panel Blower

Mount

Heater/

Blower

Assembly

Mounting

Screws

Blower Mount

Screws

Control	Hex
	Screws
Cover
Screws	Control
	Cover

Figure 21 - Disassembling Blower Mount

Figure 23 - Mounting Alternate Heater/

Blower

Knockout Plug

-Remove to Install Power

Switch

Power

Switch

Figure 24 - Installing Heater Power Switch

115121-01B www.desatech.com 11