Vanguard VE36LH Features And Operation, Accessory Installation, Continued, Optional Glass Doors

FEATURES AND OPERATION

Continued

ON/OFF	Flame Speed	Heater Switch
Switch

MAIN	HI- OFF LOW	HI- OFF LOW	HEATER
POWER
	FLAME SPEED	FLAME BRIGHTNESS

Flame Brightness

Figure 14 - Control Panel

Accessory

Installation

OPTIONAL GLASS DOORS

Models VE36L and VE32L will accept bifold glass doors that are fully operable or a fixed panel door that limits access to fireplace, (see Accessories, page 23).

Installing Bifold Glass Doors

Follow these steps to install left and right operable panels:

1.With handle down, completely fold panel on its hinges.

2.With handle facing center of firebox open- ing insert lower pivot pin on door panel into hole in bottom outer edge of firebox opening (see Figure 15).

3.Keep folded door tilted and slide upper two pins into guide track below upper facial edge of firebox opening.

4.Tilt glass assembly fully vertical until outer pivot pin snaps into mounting hole in up- per spring clip.

5.Once top and bottom pins are secured, unfold door into closed position.

6.Repeat steps 1 through 5 for opposite door assembly.

7.To adjust doors, slide partially open. Using a Phillips screwdriver, loosen hold- down screws on spring clips (see Figure 16).

8.Close both doors until evenly joined at middle and note gap as measured to outer edges of front face.

9.Reopen each door one at a time and retighten the hold-down screw while pre- serving noted gap at each edge.

10.Repeat process until both doors are even- ly joined, spaced and working freely.

Spring Clip

Depress Spring

Clip to Release

Pivot Pin

Fold Bifold Door

After Releasing

Spring Clip to

Slide Door Out of

Upper Track

Remove Pivot Pin

From Bottom Face

While Sliding Door

Out of Upper Track

Pivot Pin

Figure 15 - Installing/Removing Glass

Doors

Side Front
Face	Spring Clip

Partially

Opened

Door

Figure 16 - Adjust Glass Door

www.desatech.com115121-01B