Vantec UGT-ST310R BIOS Configuration, Driver Installation, For Windows, For A New Installation

BIOS Configuration

The 6-Port SATA II 150 PCI Host Card w/RAID BIOS will appear every time your system starts up. If the BIOS doesn’t show, please try your controller in another PCI slot. During this (POST) process, the BIOS will show up and indicate the devices attached to it.

Driver Installation

For Windows® 2000

For A New Installation

A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the “UGT-ST310R\2000_XP_2003_Vista\32bit” folder, found on the driver CD, onto a blank floppy disk then follow the directions below.

1.Setup the RAID Array prior to Windows installation.

2.Follow Windows® 2000 installation procedure.

3.At the Windows® 2000 Setup screen, press F6 to install the RAID driver.

4.When prompted, press S to specify the location of the driver.

5.Insert the floppy disk, then press Enter.

6.Select Silicon Image SiI 3114 SoftRAID 5 Controller for Windows 2000, then press Enter.

7.Press Enter again to finish driver installation, then follow the on-screen instructions to complete the Windows installation.

For An Existing Installation

1.Setup the RAID Array prior to driver installation and boot up

UGT-ST310R Page 15