Vantec UGT-ST310R user manual To Verify Windows Installation, For Windows Vista-x64

3.Please insert driver CD, click Next.

4.Click Close to complete the installation.

For Windows® Vista-x64

For A New Installation

A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the “UGT-ST310R\XP_2003_Vista\64bit” folder, found on the driver CD, onto a blank floppy disk then follow the directions below.

1.Setup the RAID Array prior to Windows installation.

2.Follow Microsoft’s Windows installation procedure.

3.At the Windows Setup screen, press Load Driver to install the RAID driver.

4.Insert the floppy disk, please select Silicon Image SiI 3114 SoftRAID 5 Controller (A:\si3114r5.inf), then press Next. (Change A:\ to match your floppy drive letter)

5.Follow the on-screen instructions to complete the Windows installation.

For An Existing Installation

1.Setup the RAID Array prior to driver installation and boot up to Windows.

2.At Found New Hardware Wizard, select Locate and install driver software (recommended).

3.Please insert the driver CD, click Next.

4.Click Close to complete the installation.

To Verify Windows® Installation

1.Right click My Computer and click Manage.

UGT-ST310R Page 19