Vantec UGT-ST310R For Windows Vista, For A New Installation, For An Existing Installation

1.Setup the RAID Array prior to driver installation and boot up to Windows.

2.At the Found New Hardware Wizard, select No, not this time, then click Next.

3.Insert the driver CD, select Install the software automatically (Recommended), and click Next.

4.Click Finish.

5.Restart Windows to complete the driver installation.

For Windows® Vista

For A New Installation

A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the “UGT-ST310R\2000_XP_2003_Vista\32bit” folder, found on the driver CD, onto a blank floppy disk then follow the directions below.

1.Setup the RAID Array prior to Windows installation.

2.Follow Microsoft’s Windows installation procedure.

3.At the Windows Setup screen, press Load Driver to install the RAID driver.

4.Insert the floppy disk, please select Silicon Image SiI 3114 SoftRAID 5 Controller (A:\si3114r5.inf), then press Next. (Change A:\ to match your floppy drive letter)

5.Follow the on-screen instructions to complete the Windows installation.

For An Existing Installation

1.Setup the RAID Array prior to driver installation and boot up to Windows.

2.At Found New Hardware Wizard, select Locate and install driver software (recommended).

UGT-ST310R Page 18