Vermont Casting RHE42 B3 RHEFA and RHEFP Trims, RHEFA & RHEFP Trim Replacement Parts, 10000836

Vermont Castings, Majestic Products RHE Natural Vent Insert

B3 RHEFA and RHEFP Trims

For use with RHEDV32

Trim Assembly

1.Remove the front glass (Refer to "Glass Frame Removal" section).

2.Install support window trim channel, top and bottom brass trim by using the shortest black screw. (Fig. 45 & 46)

3.Install bottom decorative plate by simply sliding it under the unit floor. No fastening is required for this installation. (Fig. 47) Be sure to remove protective cover.

4.Install the bottom louvre assembly by fastening the hinges with four (4) screws to the pre-punched holes in the cabinet.

5.Re-install the front glass.

6.Install the top louvre by using the hooks to hang it in place.

Trim Top

Screws

Glass Frame

Trim Bottom

FP1295

Fig. 45 Install support window trim channel and top and bottom brass trim.

Louvre

NOTE: Position brass trim top as shown (small end up) to prevent heat discoloration.

Glass Frame

FP1291

Fig. 46 Position brass trim to with small end up.

Bottom

Decorative

Plate

FP1292

Fig. 47 Slide bottom decorative plate under unit floor.

RHEFA & RHEFP Trim Replacement Parts

1

2

3

4

6	5
	FP1296

Vermont Castings, Majestic Products reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice.

IMPORTANT: Only trim panel assemblies approved by Vermont Castings, Majestic Products can be used on these products.

ALL repair parts will be available from your local dealer. When ordering, always give the following information: Model and serial number, part description with finish and part number.

Key	Description	RHEFA	RHEFP
1	Trim Window
	Top/Bottom	52624-AB	52624-PB
2	Plate Decorative
	Bottom	17597-AB	17597-PB
3	Top Louvre Assembly	57905	57905
4	Bottom Louvre
	Assembly	57906	57906
5	Support Window
	Trim Channel	57909	57909
6	Hinge	52356	52356
7	Fasteners Package
	(Not Shown)	57916	57916

30 10000836