Vermont Castings, Majestic Products RHE Natural Vent Insert
A4 Riser Kits
For use with RHEDV25 (Refer to Page 34, Figure 55)
1.Install the unit according to Homeowner’s Manual.
2.Install the trim according to Installation Instructions.
3.Remove the two (2) screws at the bottom of the trim.
4.Install the riser at the bottom of the trim. (Fig. 55)
5.Fasten the trim with the same two (2) screws removed in Step 3.
Riser Trim Dimensions
| Length - A | Height - B | Depth - C |
38.3" (973mm) | 1" (25.6mm) | 2.86" (72.8mm) | |
38.3" (973mm) | 2" (50.9mm) | 2.89" (73.6mm) | |
38.3" (973mm) | 5" (127.9mm) | 2.86" (72.8mm) |
3.Install the trim top deflector and use two (2) screws to fasten it. (Fig. 40 & 41)
4.Remove ALL plastic protective covering from brass trim.
| Trim Top |
|
| Channel |
|
Trim |
|
|
Side |
| Trim |
Channel | Side | |
| Deflector | Channel |
| Trim Top |
|
Screw |
|
|
|
| FP1260 |
Fig. 40 | Install trim channels and trim top deflector. |
|
B Trim Options for RHE32
B1 RHESS, RHESL, RHESSD, RHESLD, &
RHESXL Trims
For use with RHEDV32
Frame Assembly
RHESS, RHESL, RHESSD, RHESLD and RHESXL
1.Lay Trim Top Facing and Trim Side Facings, face down on to an even surface such as a table or floor. Be sure not to scratch the painted surfaces.
2.Install the nuts and bolts. (Fig. 39)
10/24 Screws |
Frame Top |
| 10/24 Nuts |
Left | Right Frame |
Frame | |
| FP1259 |
Fig. 39 Attache left and right frame to frame top.
Trim Assembly
RHESS, RHESL and RHESXL (Fig. 40)
1.Install trim channels (left and right sides). Use two
(2) screws to assemble each piece.
2.Slide on the trim top channel and fasten it from the back side.
Side View
Trim Top Deflector
Trim Frame Top
Section
FP1261a
Fig. 41 Trim top deflector.
RHESSD and RHESLD (Fig. 42)
1.Install trim channels (left and right sides). Use two
(2)screws to assemble each piece.
2.Peel off plastic protective covering from top edges of the inner sides where they will be covered by the inner top trim facing.
3.Place the trim facing inner top in place (do not fasten it yet). Peel off the plastic protective covering from the bottom edge.
4.Install the trim top deflector and fasten it (will hold the inner top piece). Use two (2) screws to assemble them.
5.Install trim channels (left and right sides). Use two
(2)screws to assemble each piece.
6.Slide on the trim top channel and fasten it from the back side.
7.Remove ALL plastic protective covering from brass trim.
26 | 10000836 |