Vermont Castings, Majestic Products RHE Natural Vent Insert
1.Install trim channels (left and right sides) by remov- ing the two (2) screws that hold the side brass trim and put them back to hold both parts.
2.Slide on the trim top channel and fasten it from the back side.
3.Remove the two (2) screws that hold the top brass trim.
4.Install the two (2) brackets to the studs in the bottom of the top channel. Use the nuts supplied with the kit.
5.Reinstall the two (2) screws to hold the top trim channel.
A flat louvre kit OR a bay window kit need to be chosen to complete the installation.
RHE42SSP & RHE42LP Replacement Parts | ||||
|
| 4 |
|
|
5 | 3 | 2 | 3 | 5 |
|
| |||
|
| 1 |
|
|
|
| 7 |
|
|
|
|
|
| FP1297 |
Vermont Castings, Majestic Products reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice.
IMPORTANT: Only Trim Panel Assemblies Approved by Vermont Castings, Majestic Products Can Be Used on These Products.
ALL repair parts will be available from your local dealer.
When ordering, always give the following information: Model and serial number, part description with finish and part number;
Key | Description | RHE42SSP | RHE42LP(1) |
1 | Frame Trim Kit |
|
|
| (Metallic Black) | 10000931 | - |
2 | Trim Top Channel | 57508 | - |
3 | Trim Side Channel | 57509 | - |
4 | Trim Top Channel | - | 57511 |
5 | Trim Side Channel | - | 57507 |
6 | Fasteners Package |
|
|
| (Not Shown) | 54618 | - |
7 | Trim Top Deflector | 10000912 | - |
(1)LP trim to be used with SSP trim.
SSP trim dimensions are for openings smaller than 30³⁄₄" H x 42⁷⁄₈"W (781mm x 1089mm)
LP trim dimensions are for openings smaller than 33³⁄₁₆"H x 48"W (846mm x 1225mm)
C2 RHE42FP Trim
For use with RHEDV42
RHE42FP Flat face louvres with polished window brass trim
Trim Assembly
1.Remove the front glass (Refer to "Glass Frame Removal" section).
2.Install top and bottom brass trim (Fig. 59 & Fig. 60) Use the shortest black screw.
4.Install bottom decorative plate by simply sliding it under the unit. No fastening is required for this installation. (Fig. 61) Be sure to remove the protec- tive plastic cover from the trim.
5.Install the bottom louvre assembly by fastening the hinges with four (4) screws to the
6.
7.Install the top louvre assembly by using the hooks to hang it in place.
Trim Top |
Screws |
Glass Frame |
Trim Bottom |
FP1295 |
Fig. 59 Install support window trim channel and top and bottom brass trim.
Louvre
NOTE: Position brass trim top as shown (small end up) to prevent heat discoloration.
Glass Frame
FP1291
Fig. 60 Position brass trim to with small end up.
10000836 | 35 |