Vidikron Vision 15ET/CineWideTM operation manual Installation

Operation

To access the Installation adjustments, press MENU, then press the or button to highlight Installation and press ENTER. The Installation sub-menu appears. Press EXIT to return to the previous menu or press MENU to close all menus.

When you change a setting in the Installation menu, the change takes effect

Note immediately; you do not need to press ENTER afterwards. (Press EXIT to return to the previous menu or MENU to exit.)

Language: Select Language from the Installation menu and press ENTER. Then, use the or button to select from the available languages: English, French, Spanish, German and

Italian.

Orientation: Select Orientation from the Installation menu and press ENTER. Then, use the or button to change the orientation of the projected image. The Vision 15 can be installed on a ceiling or in a rear-screen configuration with one or more mirrors. There are

four settings: Floor Front, Ceiling Front, Floor Rear and Ceiling Rear.

Keystone: Projector placement and other factors can cause geometric distortion in the projected image. To correct this, select Keystone from the Installation menu. This sub-menu provides the following options:

•V. Keystone/H. Keystone: To correct distortion resulting from the angle of projection,

select V. Keystone or H. Keystone from the Keystone menu and use the or button to make the image rectangular. See Figure 4-6.

Tip	Vidikron recommends that the keystone feature not be used unless
	absolutely necessary, as it may cause artifacts in the image.
Note	1. The Vision 15 keystone correction can compensate for up to
	approximately 15 degrees of screen and/or projector tilt.

2.Straight lines or the edges of images may appear jagged while adjusting the image.

Installation

Installation

Language

Orientation

Keystone

Overscan

YUV/RGB Adjust

OSD Timeout

Vertical Correction

V. Keystone	0
H. Keystone		0

Vidikron Vision Model 15 Installation/Operation Manual 45