Continuous Calling Tone, Touch | ViewSonic EXES-2000 manual

3. CONTINUOUS CALLING TONE

			CONTINUOUS CALLING TONE
		STEP 1
			Touch
			Function		Code
			New Registration?			NO
			New Registration?
				YES
			Continuously	Called	Station	No.
			Touch
			Continuously	Called	Station	No.
			Touch
			Confirmation		tone
		NO	New Registration		finished?
			New Registration		finished?
				YES
			Release?			NO
			Release?
				YES
			Continuously	Called	Station	No.
			Touch
			Continuously Called Station			No.
			Touch
			Confirmation		tone
		NO	Release finished?
			Release finished?
				YES
			Return
NOTES
1. To allow all the stations to	have this	function,			3. Re-start at Step 1 when mis-dialing occurs.
Touch		(Confirmation tone			(All	other registrations remain valid.)
		(Confirmation tone
		will be heard.)
		will be heard.)
	10 times
Be sure to depress the	key	steadily.

2.To release at one time the data programmed into all the stations for this function,

(Confirmation tone

Touch

will be heard.)

10 times

– 24 –

Image 25

ViewSonic EXES-2000 manual Continuous Calling Tone, Will be heard Times Be sure to depress Key Steadily, Touch

Contents

EX-200 Before Reading this Hand Book Contents Examples of system configuration Description and featuresPower BGM distribution up to 3 channels Power transformer unit PU-200 Remote control unit RC-20Central control unit CC-20 Line modem unit LM-20 Installation of equipment Installing and adjusting proceduresSelection of the place to install Dimensions Installation of the exchange Installing FC-210 extension cabinet Installation of PU-200 power supply unit Wall Base Case For case Switch boxFor plate R51 or R59 390k ohms on the LM unit corresponding to Cable installationExchange Indoor ExchangeterminalStations board Addition of LM unit Connection of equipmentEstablishment of the LM unit number Mounting LM unit For the system with up to 16 stations LM unit wiring Mounting option unit Bl unit Connection of station plug to jackMounting other option units than the Bl unit Bl unit connection Alarm tone, etcBGM equipment PTT.C PTT control RC unit connectionDoor locking Radio Station Equipment Maximum contact capacity 125 VA 125V AC or 30V DC 1A PC unit connectionSerial data output Tl unit connection SM unit number setting Connection for speaker station Service distance Voltage selector Connection of power source Initial set-up and programming No programming Procedures of initial set-up and No programming Door remote control 2 circuits PA paging & power remote/3-channel general purpose controlTransfer Secretary transfer Hurry up EX-610/620/630 Registration of each function Highest Executive Priority Will be heard Times Be sure to depress Key Steadily Continuous Calling ToneTouch Stations Allowed Access to Paging Allowed Station No Stations Allowed Access to Emergency Call Will be heard Handset Station Registration Times Be sure to depress Key Steadily Have this Function Allowed Stations Allowed Access to Speech Message Door Substation Registration Release finished? Secretary Transfer MASTER/SUB Relationship Registration of Stations to Refuse ALL-CALL Paging Dial Will be heard Times Registration of Station to Refuse Zone 1 Paging Repeat twice Registration of next allowed station Registration of Stations to Refuse Zone 2 Paging Registration of Stations to Refuse Zone 3 Paging Step Speech and Function Tests Speech Test Performance TestMethod of Speech test Hands-free conversation Handset conversation Trouble-shooting at the time of installation Replace station Noise is heard from the station Door Substation Function Table for Stations Station Data Table Station Data Table 3 0 6 1 3 5 6 C