Stations Allowed Access to Speech Message | ViewSonic EXES-2000

8. STATIONS ALLOWED ACCESS TO SPEECH MESSAGE

STATIONS ALLOWED ACCESS TO SPEECH MESSAGE

STEP 1

Touch

Function Code

New Registration?

YES

NO

Allowed Station No.

Touch

			Allowed		Station		No.
			Touch
				Confirmation		tone
		NO	New	Registration		finished?
			New	Registration		finished?
					YES
				Release?			NO
				Release?
					YES
			Allowed		Station		No.
			Touch
			Allowed		Station No.
			Touch
				Confirmation tone
		NO		Release finished?
				Release finished?
					YES
				Return
NOTES
1. To allow all the stations to	have this	function,				3. Re-start at Step 1 when mis-dialing occurs.
		(Confirmation		tone			(All other registrations remain valid.)
Touch		(Confirmation		tone
Touch		will be heard.)
		will be heard.)
	10 times
Be sure to depress the	key	steadily.

2.To release at one time the data programmed into all the stations for this function,

(Confirmation tone

Touch

will be heard.)

10 times

– 29 –

Image 30

ViewSonic EXES-2000 manual Stations Allowed Access to Speech Message

Contents

EX-200 Contents Before Reading this Hand Book Power Description and featuresExamples of system configuration BGM distribution up to 3 channels Central control unit CC-20 Remote control unit RC-20Power transformer unit PU-200 Line modem unit LM-20 Installing and adjusting procedures Installation of equipmentSelection of the place to install Installation of the exchange Dimensions Installing FC-210 extension cabinet Installation of PU-200 power supply unit For case Switch box Wall Base CaseFor plate Exchange Cable installationR51 or R59 390k ohms on the LM unit corresponding to Indoor ExchangeterminalStations board Establishment of the LM unit number Connection of equipmentAddition of LM unit Mounting LM unit For the system with up to 16 stations LM unit wiring Connection of station plug to jack Mounting option unit Bl unitMounting other option units than the Bl unit Alarm tone, etc Bl unit connectionBGM equipment Door locking RC unit connectionPTT.C PTT control Radio Station Equipment PC unit connection Maximum contact capacity 125 VA 125V AC or 30V DC 1ASerial data output Tl unit connection SM unit number setting Service distance Connection for speaker station Connection of power source Voltage selector Procedures of initial set-up and No programming Initial set-up and programming No programming Transfer PA paging & power remote/3-channel general purpose controlDoor remote control 2 circuits Secretary transfer Hurry up Registration of each function EX-610/620/630 Highest Executive Priority Continuous Calling Tone Will be heard Times Be sure to depress Key SteadilyTouch Stations Allowed Access to Paging Stations Allowed Access to Emergency Call Allowed Station No Handset Station Registration Will be heard Have this Function Times Be sure to depress Key Steadily Stations Allowed Access to Speech Message Allowed Door Substation Registration Secretary Transfer Release finished? MASTER/SUB Relationship Registration of Stations to Refuse ALL-CALL Paging Registration of Station to Refuse Zone 1 Paging Dial Will be heard Times Registration of Stations to Refuse Zone 2 Paging Repeat twice Registration of next allowed station Registration of Stations to Refuse Zone 3 Paging Step Method of Speech test Hands-free conversation Performance TestSpeech and Function Tests Speech Test Handset conversation Trouble-shooting at the time of installation Noise is heard from the station Replace station Function Table for Stations Door Substation Station Data Table Station Data Table 3 0 6 1 3 5 6 C