Stations Allowed Access to Emergency Call | ViewSonic EXES-2000

5. STATIONS ALLOWED ACCESS TO EMERGENCY CALL

STATIONS ALLOWED ACCESS TO EMERGENCY CALL

STEP 1

Touch

Function Code

New Registration?

YES

NO

Allowed Station No.

Touch

Allowed Station No.

Touch

NO

Confirmation tone

New Registration finished?

YES

Release?

NO

YES

Allowed Station No

Touch

Allowed Station No.

Touch

NO

Confirmation tone

Release finished?

YES

Return

1. To allow all the stations to have this function,

(Confirmation tone

Touch

will be heard.)

10 times

Be sure to depress the

key steadily.

2.To release at one time the data programmed into all the stations for this function,

(Confirmation tone

Touch

will be heard.)

10 times

3.Re-start at Step 1 when mis-dialing occurs. (All other registrations remain valid.)

– 26 –

Image 27

ViewSonic EXES-2000 manual Stations Allowed Access to Emergency Call, Allowed Station No

Contents

EX-200 Before Reading this Hand Book Contents BGM distribution up to 3 channels Description and featuresExamples of system configuration Power Line modem unit LM-20 Remote control unit RC-20Power transformer unit PU-200 Central control unit CC-20 Installing and adjusting procedures Installation of equipmentSelection of the place to install Dimensions Installation of the exchange Installing FC-210 extension cabinet Installation of PU-200 power supply unit For case Switch box Wall Base CaseFor plate Indoor ExchangeterminalStations board Cable installationR51 or R59 390k ohms on the LM unit corresponding to Exchange Mounting LM unit For the system with up to 16 stations Connection of equipmentAddition of LM unit Establishment of the LM unit number LM unit wiring Connection of station plug to jack Mounting option unit Bl unitMounting other option units than the Bl unit Alarm tone, etc Bl unit connectionBGM equipment Radio Station Equipment RC unit connectionPTT.C PTT control Door locking PC unit connection Maximum contact capacity 125 VA 125V AC or 30V DC 1ASerial data output Tl unit connection SM unit number setting Connection for speaker station Service distance Voltage selector Connection of power source Initial set-up and programming No programming Procedures of initial set-up and No programming Secretary transfer Hurry up PA paging & power remote/3-channel general purpose controlDoor remote control 2 circuits Transfer EX-610/620/630 Registration of each function Highest Executive Priority Continuous Calling Tone Will be heard Times Be sure to depress Key SteadilyTouch Stations Allowed Access to Paging Allowed Station No Stations Allowed Access to Emergency Call Will be heard Handset Station Registration Times Be sure to depress Key Steadily Have this Function Allowed Stations Allowed Access to Speech Message Door Substation Registration Release finished? Secretary Transfer MASTER/SUB Relationship Registration of Stations to Refuse ALL-CALL Paging Dial Will be heard Times Registration of Station to Refuse Zone 1 Paging Repeat twice Registration of next allowed station Registration of Stations to Refuse Zone 2 Paging Registration of Stations to Refuse Zone 3 Paging Step Handset conversation Performance TestSpeech and Function Tests Speech Test Method of Speech test Hands-free conversation Trouble-shooting at the time of installation Replace station Noise is heard from the station Door Substation Function Table for Stations Station Data Table Station Data Table 3 0 6 1 3 5 6 C