Installing FC-210 extension cabinet | ViewSonic EXES-2000 specification

4-3 Installing FC-210 extension cabinet

Follow the procedures below to install the FC-210 cabinet:

Unscrew screws that hold the top case to a chassis at 4 places in the sides of a cabinet.

Insert attached brackets (2 pieces) into bracket	Fit bracket receptacles of the FC-210 into the
receptacles on the bottom case of the EX-200.	brackets.
	Fix the cabinet on the wall through fixing holes
	provided on its bottom case.
(EX-200)	Connect the connector CN-5 on the CC-20 card
	mounted in the EX-200 to the connector CN-4 on the
	printed circuit board of the FC-210 using the
	attached GND connector.
	Remove a rubber membrane of 2 bushings on the
	bottom case of the EX-200 and FC-210 to allow the
	cable entry.

Bracket

Bracket

Knock-out hole (for wiring)

(FC-210)

Note

(1)Since the YR-820 and YR-821 cables are to be used for connecting the FC-210 to the EX-200 exchange, there is a limit to spacing between the two units. You should allow for this limit and fix them according to dimensions shown at right when they are mounted on the wall.

(2)Allow for sufficient spacing for screwing and un-

screwing the top cover when mounting on the wall.	Knock-out hole (for wiring)	Dimensions
screwing the top cover when mounting on the wall.

– 6 –

Image 7

ViewSonic EXES-2000 manual Installing FC-210 extension cabinet

Contents

EX-200 Before Reading this Hand Book Contents BGM distribution up to 3 channels Description and featuresExamples of system configuration Power Line modem unit LM-20 Remote control unit RC-20Power transformer unit PU-200 Central control unit CC-20 Installation of equipment Installing and adjusting proceduresSelection of the place to install Dimensions Installation of the exchange Installing FC-210 extension cabinet Installation of PU-200 power supply unit Wall Base Case For case Switch boxFor plate Indoor ExchangeterminalStations board Cable installationR51 or R59 390k ohms on the LM unit corresponding to Exchange Mounting LM unit For the system with up to 16 stations Connection of equipmentAddition of LM unit Establishment of the LM unit number LM unit wiring Mounting option unit Bl unit Connection of station plug to jackMounting other option units than the Bl unit Bl unit connection Alarm tone, etcBGM equipment Radio Station Equipment RC unit connectionPTT.C PTT control Door locking Maximum contact capacity 125 VA 125V AC or 30V DC 1A PC unit connectionSerial data output Tl unit connection SM unit number setting Connection for speaker station Service distance Voltage selector Connection of power source Initial set-up and programming No programming Procedures of initial set-up and No programming Secretary transfer Hurry up PA paging & power remote/3-channel general purpose controlDoor remote control 2 circuits Transfer EX-610/620/630 Registration of each function Highest Executive Priority Will be heard Times Be sure to depress Key Steadily Continuous Calling ToneTouch Stations Allowed Access to Paging Allowed Station No Stations Allowed Access to Emergency Call Will be heard Handset Station Registration Times Be sure to depress Key Steadily Have this Function Allowed Stations Allowed Access to Speech Message Door Substation Registration Release finished? Secretary Transfer MASTER/SUB Relationship Registration of Stations to Refuse ALL-CALL Paging Dial Will be heard Times Registration of Station to Refuse Zone 1 Paging Repeat twice Registration of next allowed station Registration of Stations to Refuse Zone 2 Paging Registration of Stations to Refuse Zone 3 Paging Step Handset conversation Performance TestSpeech and Function Tests Speech Test Method of Speech test Hands-free conversation Trouble-shooting at the time of installation Replace station Noise is heard from the station Door Substation Function Table for Stations Station Data Table Station Data Table 3 0 6 1 3 5 6 C