ViewSonic EXES-2000 guide

12. REGISTRATION OF STATIONS TO REFUSE ALL-CALL PAGING

REGISTRATION OF STATIONS

TO REFUSE ALL-CALL PAGING

		Step 1	Dial
			Function code
		Yes.	No.
		Registration	New registration?
		Registration
(allowed station No.)			(allowed station No.)
Dial			Dial
Step 2	plus	Confirmation	Step 2	plus	Confirmation
	plus	tone		plus	tone
		tone			tone
Repeat	twice.		Repeat	twice.

No.

Registration finished?

Registration of next allowed station.

Yes.

Other registration mode

or registration finished.

NOTES

1.All the stations are registered for this function when initial set-up is made.

2.To cancel at one time the data programmed into all the stations for this function,

4.To register stations having consecutive station numbers for this function, First station No. Last station No.

Dial

Dial

(Confirmation tone will be heard.)

Repeat twice.

10times

3.To register all the stations for this function,

(Confirmation tone

Dial

will be heard.)

10 times

5.Re-start at Step 1 when mis-dialing occurs. (All other registrations remain valid.)

Depress the

key steadily.

– 33 –

Image 34

ViewSonic EXES-2000 manual Registration of Stations to Refuse ALL-CALL Paging

Contents

EX-200 Contents Before Reading this Hand Book Power Description and featuresExamples of system configuration BGM distribution up to 3 channels Central control unit CC-20 Remote control unit RC-20Power transformer unit PU-200 Line modem unit LM-20 Installation of equipment Installing and adjusting proceduresSelection of the place to install Installation of the exchange Dimensions Installing FC-210 extension cabinet Installation of PU-200 power supply unit Wall Base Case For case Switch boxFor plate Exchange Cable installationR51 or R59 390k ohms on the LM unit corresponding to Indoor ExchangeterminalStations board Establishment of the LM unit number Connection of equipmentAddition of LM unit Mounting LM unit For the system with up to 16 stations LM unit wiring Mounting option unit Bl unit Connection of station plug to jackMounting other option units than the Bl unit Bl unit connection Alarm tone, etcBGM equipment Door locking RC unit connectionPTT.C PTT control Radio Station Equipment Maximum contact capacity 125 VA 125V AC or 30V DC 1A PC unit connectionSerial data output Tl unit connection SM unit number setting Service distance Connection for speaker station Connection of power source Voltage selector Procedures of initial set-up and No programming Initial set-up and programming No programming Transfer PA paging & power remote/3-channel general purpose controlDoor remote control 2 circuits Secretary transfer Hurry up Registration of each function EX-610/620/630 Highest Executive Priority Will be heard Times Be sure to depress Key Steadily Continuous Calling ToneTouch Stations Allowed Access to Paging Stations Allowed Access to Emergency Call Allowed Station No Handset Station Registration Will be heard Have this Function Times Be sure to depress Key Steadily Stations Allowed Access to Speech Message Allowed Door Substation Registration Secretary Transfer Release finished? MASTER/SUB Relationship Registration of Stations to Refuse ALL-CALL Paging Registration of Station to Refuse Zone 1 Paging Dial Will be heard Times Registration of Stations to Refuse Zone 2 Paging Repeat twice Registration of next allowed station Registration of Stations to Refuse Zone 3 Paging Step Method of Speech test Hands-free conversation Performance TestSpeech and Function Tests Speech Test Handset conversation Trouble-shooting at the time of installation Noise is heard from the station Replace station Function Table for Stations Door Substation Station Data Table Station Data Table 3 0 6 1 3 5 6 C