Have this Function | ViewSonic EXES-2000 guide

7. STATIONS ALLOWED ACCESS TO DOOR REMOTE CONTROL AND GENERAL PURPOSE CONTROL

STATIONS ALLOWED ACCESS TO DOOR REMOTE CONTROL AND GENERAL PURPOSE CONTROL

STEP 1

Touch

			Function Code
					NO
			New Registration?
				YES
			Allowed Station		No.
			Touch
			Allowed	Station	No.
			Touch
			Confirmation tone
		NO	New Registration finished?
			New Registration finished?
				YES
			Release?		NO
			Release?
				YES
			Allowed	Station	No.
			Touch
			Allowed	Station	No.
			Touch
			Confirmation tone
		NO	Release finished?
			Release finished?
				YES
			Return
NOTES
1. To allow all the stations to	have this	function,		3.	Re-start at Step 1 when mis-dialing occurs.
Touch		(Confirmation tone			(All other registrations remain valid.)
		(Confirmation tone
		will be heard.)
		will be heard.)
	10 times
Be sure to depress the	key	steadily.

2.To release at one time the data programmed into all the stations for this function,

(Confirmation tone

Touch

will be heard.)

10 times

– 28 –

Image 29

ViewSonic EXES-2000 manual Have this Function, Times Be sure to depress Key Steadily

Contents

EX-200 Before Reading this Hand Book Contents Examples of system configuration Description and featuresPower BGM distribution up to 3 channels Power transformer unit PU-200 Remote control unit RC-20Central control unit CC-20 Line modem unit LM-20 Selection of the place to install Installing and adjusting proceduresInstallation of equipment Dimensions Installation of the exchange Installing FC-210 extension cabinet Installation of PU-200 power supply unit For plate For case Switch boxWall Base Case R51 or R59 390k ohms on the LM unit corresponding to Cable installationExchange Indoor ExchangeterminalStations board Addition of LM unit Connection of equipmentEstablishment of the LM unit number Mounting LM unit For the system with up to 16 stations LM unit wiring Mounting other option units than the Bl unit Connection of station plug to jackMounting option unit Bl unit BGM equipment Alarm tone, etcBl unit connection PTT.C PTT control RC unit connectionDoor locking Radio Station Equipment Serial data output PC unit connectionMaximum contact capacity 125 VA 125V AC or 30V DC 1A Tl unit connection SM unit number setting Connection for speaker station Service distance Voltage selector Connection of power source Initial set-up and programming No programming Procedures of initial set-up and No programming Door remote control 2 circuits PA paging & power remote/3-channel general purpose controlTransfer Secretary transfer Hurry up EX-610/620/630 Registration of each function Highest Executive Priority Touch Continuous Calling ToneWill be heard Times Be sure to depress Key Steadily Stations Allowed Access to Paging Allowed Station No Stations Allowed Access to Emergency Call Will be heard Handset Station Registration Times Be sure to depress Key Steadily Have this Function Allowed Stations Allowed Access to Speech Message Door Substation Registration Release finished? Secretary Transfer MASTER/SUB Relationship Registration of Stations to Refuse ALL-CALL Paging Dial Will be heard Times Registration of Station to Refuse Zone 1 Paging Repeat twice Registration of next allowed station Registration of Stations to Refuse Zone 2 Paging Registration of Stations to Refuse Zone 3 Paging Step Speech and Function Tests Speech Test Performance TestMethod of Speech test Hands-free conversation Handset conversation Trouble-shooting at the time of installation Replace station Noise is heard from the station Door Substation Function Table for Stations Station Data Table Station Data Table 3 0 6 1 3 5 6 C