Power On/Off
WARNING
•When the power is “On”, a strong light is emitted. Do not look into the lens or vents of the projector.
NOTE
•Turn the power on/off in right order. Please power on the projector before the connected devices. Power off the projector after the connected devices.
Turning On The Power
1Remove the lens cap.
2Set the power switch to [ ] (On).
The STANDBY/ON indicator will light to solid orange.
3Press the STANDBY/ON button.
The projector lamp will light up and the STANDBY/ ON indicator will begin blinking green. When the power is completely on, the indicator will stop blinking and light green.
4Select an input signal according to the section “Selecting An Input Signal” of the following page.
STANDBY/ON button / indicator
STANDBY/ON button
Power switch (On position)
Turning Off The Power
1Press the STANDBY/ON button.
The message “Power off?” will appear on the screen for approximately 5 seconds.
2Press the STANDBY/ON button again while “Power off?” message is visible.
The projector lamp will go off, and the STANDBY/ ON indicator will begin blinking orange. The STANBY/ON indicator will stop blinking and light to solid orange when the lamp cooling is complete.
3Set the power switch to [O] (Off).
The STANDBY/ON indicator will go off.
4Attach the lens cap.
STANDBY/ON button / indicator
STANDBY/ON button
Power switch (Off position)
ViewSonic PJ1172 | 13 |
