OPTION Menu
With the OPTION menu, the items shown in the table below can be performed. Perform each operation in accordance with the instructions in the table below.
Item | Description |
|
|
VOLUME | Adjust the volume using the S/T buttons.: |
| High Low |
|
|
SPEAKER | Select TURN ON or TURN OFF using the S/T buttons.: |
| TURN ON TURN OFF |
| When TURN ON is selected, the |
|
|
IR REMOTE | Select a remote sensor using the S/T button (1), then |
| switch it using the ENTER button (2).: |
| (1) FRONT TOP REAR (2) (Off) (On) |
| memo A sensor cannot be turned off when the other two are |
| off. Always at least one sensor is on. |
|
|
IR REMOTE ID | Select a number as an ID number for remote control using the S/T |
| buttons.: |
| ALL 1 2 3 |
| The projector is controlled by the remote control whose ID CHANGE |
| switch is set into the position of the same number as this number. |
| When the ALL is selected, the projector is controlled by a remote |
| control irrespective of the position of the ID CHANGE switch. |
| memo Please refer to the section “Using The Remote ID Feature”. |
|
|
LAMP TIME | Pressing the RESET button for about 3 seconds displays the LAMP |
| TIME menu. |
| Select the RESET using S button to reset the timer.: |
| RESET CANCEL |
| Selecting the RESET resets the count of the lamp timer to 0. |
| memo Perform this function only when you have replaced the lamp. The |
| lamp timer counts the used time of the current lamp, to display the |
| messages about the lamp. Incorrect performing causes incorrect |
| operation of the messages. |
| memo About replacing the lamp, please refer to the section“Lamp”. |
|
|
FILTER TIME | Pressing the RESET button for about 3 seconds displays the FILTER |
| TIME menu. |
| Select the RESET using S button to reset the timer.: |
| RESET CANCEL |
| Selecting the RESET resets the count of the lamp timer to 0. |
| memo Perform this function only when you have cleaned or replaced the |
| air filter. The filter timer counts the used time of the air filter after |
| cleaning or replacement, to display the messages about the air filter. |
| Incorrect performing causes incorrect operation of the messages. |
| memo About caring for the air filter, please refer to the section “Air Filter”. |
|
|
| (This table is continued to the following page.) |
ViewSonic PJ1172 | 31 |
