FRONT VIEW
1 | 2 | 3 |
4 | 5 | 6 | 7 | 8 |
1.SPEAKER A/B
If suitable speakers are used, a second pair of speakers can be operated at the same time. This button allows each of the speaker pairs (designated A and B) to be individually switched on and off. The LED located above each of the buttons shows which of the speaker pairs is active.
2.Display
In normal use the display shows the name of the selected input, the volume and the opera- ting mode (Audio Mute). When adjustments are being made (e.g. to BALANCE, GAIN), the relevant values are displayed.
3.LEVEL/: Volume keys
These are the keys for the adjustment of the main volume level of the system. They conse- quently control the volume of the loudspeakers and the signal of the stereo preamplifier out- put "PRE OUTPUT". Only for the playback of the audio source at the input "LINE5" the volume setting has no effect.
4.„LINE1“ … „LINE5“ and "BALANCED": Input selection With a touch on one of these buttons you choose for playback the audio source attached to the corresponding connec- tors at the amplifier's backside.
5.POWER
This is the main power switch for turning on and off the device. Please take note of the information about it in the sections "Installation" and "Operating the device".
6.LED signaling display shut-off
This LED remains illuminated when the display is switched off by the “DIMMER” (7) function. That helps to not misinterpret a
7.DIMMER: Brightness setting for the display
The brightness of the front panel display can be reduced in two steps using this button.
If you press it repeatedly, the third actuation switches off the display. With a fourth stroke, the maximum display brightness will be restored again.
8.CHANNEL: Channel Balance
These are the buttons that enable you to set a volume difference between the left and the right stereo channel ("BALANCE").
Vincent 27