If you want to use speaker cables equipped with spade lug connectors, every connector screw must be opened by turning counterclockwise. After that, the lug must be moved under the screw head. Then, turn the screw clockwise to fasten the lug to the connector. To avoid damages to the amplifier, make sure the connection is tight and no bare metal from the cable lug connector makes contact with the rear panel or with another terminal.
If no connector is to be used, remove approximately 1 cm length of insulation from each end of the spea- ker wire. Twist the braid in order to avoid short circuits. Turn the fastener on the loudspeaker terminal coun- terclockwise to loosen it and introduce the bare wire end into the exposed connector hole. Then turn the fastener clockwise so that the wire is firmly clamped. Make sure the connection is pretty tight.
If you intend to connect two pairs of speakers, all loudspeakers must have a nominal impedance of at least 8Ω. If only one pair of speakers is used (A or B), all types of loudspeakers with a mini- mal nominal impedance of 4Ω can be utilised.
Consider correct polarity, the positive contact is mostly marked red or with "+". The side of the speaker cable that has to be connected with the positive socket has a marking.
CONNECTION OF THE POWER CABLE
Check whether the wall socket provides the appropriate mains power, which is the case if it is supplied with 230 V AC 50 Hz. Push the plug on the power cable supplied firmly into the power socket (16) on the back of the appliance. Plug the other end of the power cable into a mains socket.
Vincent 37
