Vincent Audio SV-234 Technical Specifications, 42Vincent, Symptom, Possible Cause, Countermeasure

Symptom	Possible Cause	Countermeasure
Front panel display	It has been switched off before using	Press the button "DIMMER" (7) one more time.
does not work	"DIMMER" (7).
Poor sound quality	The cable connections are not tight, the	Check the cables and cable connections.
	connectors are dirty or a cable is defective.
	A record player has been connected to a high	Interconnect a phono preamplifier.
	level input without using a phono preamplifier.
	An audio source with standard line level	Use line level audio sources only at the
	output is connected to the amplifier direct	inputs "LINE1"..."LINE4".
	input "LINE5" (11).
The remote control	No batteries inserted in the remote control,	Check and replace the batteries if necessary.
cannot perform any	batteries are not inserted correctly or are
	depleted.
functions
	The line-of-sight between the remote control	Try to point the remote control at the front of
	and the unit is obstructed, the range was	the unit only when the sight-line is clear,
	exceeded or the hand unit was operated from	within a 7-metre distance and, if possible,
	a position too far to one side.	facing the unit.
	The unit is not switched on.	Switch on the unit.
Humming low	See section "Net frequency noise" in the chapter "Tips".
frequency noise is
audible, even as
no audio source is
playing back

TECHNICAL SPECIFICATIONS

Frequency response:	20 Hz - 20 kHz ±0,5 dB
Nominal Output Power at 8Ω:	200 W
Nominal Output Power at 4Ω:	289 W
Input sensitivity:	400 mV
Total Harmonic Distortion:	< 0.1%
Signal to Noise Ratio:	>90 dB
Input Impedance:	47 kΩ
AC power connection type:	220-240V/50Hz
Inputs:	4x	RCA stereo, 1x RCA Main Input stereo,
	1x	XLR stereo, 1x Power Control (3,5 mm jack)
Outputs:	Speaker connectors accepting 4 speakers,
	1x	PRE stereo RCA, 1x REC stereo RCA,
	2x	Power Control (3,5 mm jack)
Dimensions:	430 x 142 x 450 mm
Weight:	20 kg
Colour:	silver / black

42Vincent