S T E P 2 | BLUE BAG | |
| • Place the center connecting support | |
| (AC6) in between the functional arm floor | |
| support and the leg press arm floor | |
| support, aligning the holes. Slide two bolts | |
| (M10x62) with flat washers (10.2x22x2) | |
| through the holes into the functional arm | |
| floor support. Secure bolts with two more | |
| flat washers and two nylon nuts (M10). | |
| Repeat on other side of connecting support. | |
| • Attach two pillow block bearings (C33) | |
| to the leg press foot (AC4) with four | |
| bolts (M10x25), four lock washers | |
| (10.2x18.4x2.5), and four flat washers | |
| (10.2x22x2). Make sure the grease fittings | |
| are positioned on the inside, pointing | |
| towards the main center upright. Tighten. | |
| • Take the leg press foot (AC4) and place | |
| over the end of the leg press floor support | |
| (AC3), aligning the holes. Slide two bolts | |
| (M10x62) with flat washers (10.2x22x2) | |
| through the holes, securing with two more | |
| flat washers and two nylon nuts (M10). | |
| • Loosely thread four set screws (M6x8) in | |
| the axle housing on the leg press swing | |
AN2 | arm (AN1). Place the axle (8 7/16”) housing | |
AN1 | of the leg press swing arm between the | |
pillow block bearings on the leg press | ||
| foot, making sure the pulley bracket is facing | |
| the floor support. Slide the axle through | |
| the holes and center it in the bearings. | |
| Secure by tightening set screws. | |
C33 |
| |
| • Attach the foot plate (AN2) to the leg | |
| press swing arm (AN1) by sliding the shaft | |
AC4 | (5.75”) through holes in foot plate and | |
swing arm, and securing with a flat washer | ||
| ||
| (12.2x26x2), lock washer (10.2x18.4x2.5) | |
| and a bolt (M10x25). |
AC1
• Attach the leg curl post (AH2) in between the bracket on the press arm floor support (AC1) using one bolt (M10x72),
AC3two flat washers (10.2x22x2), and a nylon nut (M10).
AH2 | AC6 |
12
